Greenhouse Designer Open the designerDesign

← All posts

Dig in: pit greenhouses and walipinis

Sink the floor up to six feet into the ground for a walipini or pit greenhouse, with block or poured retaining walls, foam outside them, and stairs down from the door.

Dig a greenhouse into the ground and the earth around it does a lot of the heating for you. A few feet down, the soil stays at much the same temperature all winter. That's the idea behind the walipini, or pit greenhouse, and you can now design one.

In Base, floor & benches, set a sunken floor up to 6' deep. The designer adds:

  • retaining walls of concrete block or poured concrete, on a footing, from the pit floor up to the ground
  • foam board outside the walls, from none to 4", so the warm earth isn't lost to the frosty top layer
  • stairs inside every doorway, with treads and stringers sized to the depth
  • the drainage a pit needs: perforated pipe, clear stone and a dimpled membrane

The frame stands at ground level as usual, the benches are measured from the pit floor, and the camera can go down into the pit with you. The shopping list adds the blocks or concrete, the rebar and the foam, with a note on how much you'll be digging out.

The temperature card treats the walls as earth-coupled, so you can see the difference a few feet of depth makes on a January night. Try the Passive solar pit greenhouse sample to see one.

A pit this deep is serious earthwork. The advice will remind you to have buried services marked before you dig, to dig a test hole for the water table, and to have deep walls checked by an engineer.

Try it on your own greenhouse

Everything here is in the designer now. It's free, and it runs in your browser.

Open the designer →