Better roofs: flared eaves, offset ridges and overhangs
Sweep the eaves up in a bellcast or flying curve, move the ridge off centre for a longer sunny slope, run the roof out past the gable ends, and frame in roof vents and exhaust fans.

The roof is where a greenhouse gets its character, and this month it got a lot more of it.
Eaves
Set how far the roof overhangs the walls, and give the eave a shape: straight, bellcast (a gentle flare at the bottom) or flying (a sweep that rises toward the corners). Flared eaves are built the traditional way, with a sprocket cut from a standard 2x board on every rafter tail. The blueprints give you the marking-out for each one, and the covering curves to follow them.
The ridge
A gable's ridge no longer has to sit in the middle. Slide it toward the shady side and the sunny slope gets longer, catching more low winter light. The designer keeps both eaves level for you, or keeps the overhangs equal if you'd rather.
Gable overhangs
The roof can run on past the front and back walls, each by its own amount. Past three inches it's properly framed, with fly rafters on 2x4 lookouts.
Air
Roof vents are now framed openings with a curb and a hinged sash, cut neatly into the covering between two rafters. Each end wall can take an exhaust fan or a motorised intake shutter, from 12" to 24", and the advice tells you whether your fans can change the air once a minute, as a greenhouse needs on a summer afternoon.